How much does metal 3D printing cost?

Price ranges for steel, aluminium, titanium and Inconel parts, three worked examples, and six ways to bring the number down.


The short answer

A small steel or aluminium part usually costs between €60 and €400; the same part in titanium or Inconel costs two to four times more. The price is built from machine time, metal powder, build preparation and finishing labour. Machine time usually dominates, and it depends on how much metal is melted and how tall the build is.

Indicative 2026 ranges for finished, unmachined parts made by laser powder bed fusion: stainless steel and aluminium about €2–8 per cm³ of part; titanium and Inconel about €5–15 per cm³. Large Asian platforms sit at the bottom of these ranges, European shops with inspection and short lead times at the top. Single small parts hit a minimum order value of €180–280.

Printed metal parts on a build plate surrounded by powder
Several parts share one build plate — that is why quantity lowers the price per part. Photo: René Volfík / FZU, CC BY-SA 4.0.

Six things that set the price

1. Part volume

Every cubic centimetre is melted layer by layer, 40 µm at a time. Hollow sections, lattices and topology optimisation reduce both material and machine time.

2. Build height

The recoater spreads a new layer across the whole plate however many parts are on it, so a tall part costs more machine time than a flat part of the same volume. Orientation is a cost decision, not just a quality one.

3. Alloy

Steel and aluminium powders cost tens of euros per kilo; titanium powder costs several hundred. Titanium and aluminium also need dedicated machines and inert handling.

4. Supports

Surfaces that overhang below about 45° need supports. They add material and machine time, and removing them is skilled manual work. A good design review removes many of them.

5. Finishing

Stress relief is standard. Common extras: HIP for fatigue-critical parts, ageing, bead blasting, polishing and inspection reports.

6. Quantity and lead time

Nesting parts on one plate spreads setup cost: ten parts usually cost much less per part than one prototype. Express orders that jump the queue cost about a third more.

Example prices

PartAlloySizeQtyPrice per part
Drone motor bracketTi6Al4V60×40×25 mm, 18 cm³10€159
Hydraulic manifold316L50×50×40 mm, 55 cm³2€330
Compact heat exchangerAlSi10Mg80×60×45 mm, 50 cm³5€267

Excl. VAT, EU delivery included. Calculated with our instant-price model; your file decides the final number.

How to lower the cost of your part

  • Send a STEP file, not just STL, so we can suggest geometry changes.
  • Mark only the tolerances that matter; everything else can stay as printed.
  • Avoid large flat overhangs; use 45° chamfers instead of horizontal ceilings.
  • Hollow thick sections or use lattices where stiffness allows.
  • Order several parts together so they share a build plate.

Send the file. Get a price you can plan with.

Instant price in seconds, a fixed quote with DFM notes within 24 business hours. No account and no obligation.

Get instant price